Start
Estrella trenzada, Origami
Evergreen Tree Pruning Calendar, permaculture
Evaluation of female pelvic- floor muscle, Artykuły, badania naukowe
Evi Nemeth, ebooki
Evans Jean - Serce nie sługa, Książki - Literatura piękna, Bonia, Harlequin Medical
Ewolucja koncepcji, Zarządzanie
Essential DCDC Converter, zasilacze
Estrada Rita Clay Ucieczka panny mlodej, Książki - Literatura piękna, Bonia, Harlequiny nowe różne
Evolutionary Synthesis of Pattern Recognition Systems - B. Bhanu, engineering
Ergo Proxy - 05 [Ani-Jiyuu] SG (v.1.0), Anime, Ergo Proxy, Napisy
  • zanotowane.pl
  • doc.pisz.pl
  • pdf.pisz.pl
  • anusiekx91.opx.pl

  • Esseltine-Xmas-Tree-Ornament, Rękodzieło, Origami, Bożonarodzeniowe

    [ Pobierz całość w formacie PDF ]
    Christmas tree Ornament (2000)
    By: Charles Esseltine
    1.) Start white side up. Fold
    in half. Unfold
    2.) Fold the sides into the
    centerline.
    3.) Fold the model in half so
    That the end points meet.
    Unfold
    4.) Fold the top point to
    meet the new crease.
    Unfold
    5.) Fold bottom over the
    edge of the colored section.
    6.) Fold down to form trunk.
    Like this.
     7.) Wrap the inner layers
    around the trunk. Then flip
    over.
    If you are using a LARGE
    piece of paper, you can add
    more pleats.
    8.) Zoom in. Fold the bottom
    tip upwards. Tuck the tip under
    the front edge.
    9.) Pleat
    10.) Let's take a close look at one of the
    lower pleats. Swivel fold the corner, so
    that a small bit of the tip falls below the
    bottom edge..
    11 a.) Swivel fold to narrow
    the point. Leave the tip
    below the edge alone.
    11 b.) Swivel fold complete.
    12.) Now repeat steps 10 and
    11 on the other side.
    13.) Squash one of the
    upper pleat tips. This is
    similar to step 10, but this
    one goes to the tip.
    13a.) Swivel fold the ends,
    to make the point sharper..
    14b.) Swivel fold complete.
    15.) Now repeat steps 13 and
    14 on the other side.
    16.) Pleats complete! Now flip
    the model over, and look at it
    from the bottom.
    17.) Fold the model, at a right
    angle, down the centerline
    18.) Soft crease the ends so
    that the model forms a tripod
    base, that the model will stand
    on.
    To turn it into an ornament add a bit
    of twisted wire to the point at step 7.
    [ Pobierz całość w formacie PDF ]
  • zanotowane.pl
  • doc.pisz.pl
  • pdf.pisz.pl
  • jaczytam.opx.pl
  • 
    Wszelkie Prawa Zastrzeżone! Oto smutna prawda: cierpienie uszlachetnia. Design by SZABLONY.maniak.pl.